Masonry ladder and truss reinforcement
Masonry horizontal joint reinforcement mesh include ladder-type and truss type. Ladder typereinforcements are designed to be embedded in the horizontal mortar joints of masonry walls. Itconsists of two parallel side rods with cross rods welded at 16” (400 mm) O. C., thus forming aladder configuration. Overall measurement (side-to-side rod) is approximately 2” (50 mm) lessthan the nominal wall thickness.
Usual length:3.05m
Width:50mm--100mm-150mm-200mm-250mm-300mm-350mm
Finishes conform to:
ASTM A641- (Electro galvanized )ASTM A153 Class B2- (Hot dipped after fabrication)ASTM A 82- (Cold drawn steel wire)Tensile Strength:80,000 PSI;Yield Point:70,000 PSI minimum;Reduction of Area:30 %.ASTM A951-96- (Masonry wall reinforcing)ASTM 580 Type 304- (Stainless steel)

Traditional butterfly wall Wire tie
Place across cavity and tie two skins by embedding in mortar. Includes twist to allow moisture to drip off

Double Triangle Tie
Place across cavity and tie two skins by embedding in mortar. Includes drip to allow moisture to run off. Use with a retaining disc to support and hold in place cavity insulation.

Brick welding mesh (brickweld)
Also called brick mesh,brickweld .it is widely used to reinforce brickwork and brick walls. Brick mesh is manufactured from stainless steel and galvanised wire , it lies flat on the masonry wall joint, and greatly control the cracking in masonry wall.